Now, I was spend the rest of the time in 3DS Max, modelling and applying the modifiers that would construct a virtual representation of my face
The first port of call was to build the 3D Reference Plates that would have both reference images on them and they, as the name would suggest, were there as a reference for me to follow when using the 'Line' tool (more details on this further down the post) and extruding (which will be covered in Week 3)
The 'reference plates' were in fact two 'Planes' created along the vertical so they would act as "portrait-frames" for my images
I created a 'Copy' as a duplicate so that I could then just rotate it 90degrees and have both in alignment
I then selected the 'Material Editor' and imported, through the 'Diffuse' channel, the "FaceMerge.psd", which was then able to be dragged into the working pane and appeared as shown here - all I need to do is to make sure only the front-on image shows here and the profile shot only show on t'other plate
After increasing the magnification of the image, I found that there was heavy pixelation of the image
I was able to rectify this by going into the menu tab 'Preferences' and then altering the attributes of the 'Display/Driver' so that BitMaps will maintain their resolution when applied to the 'Plates'
The 'Reference Plates' needed to have the 'UVW-Map' modifier applied so that they enabled the 'Gizmo' that allowed me to alter to position of the BitMap on the 'Plate'
This then allowed me to rotate the Profile image on the second plate to face outwards (although not shown here), which I could then line up to follow the form of the Front-on image
Once I was happy with the postioning of both 'Reference Images' on both 'Plates', I could then set about beginning the incricate task of etching out all the 'Quadragraphic' lines that were all around my face - the techinique is to see each curve and follow both lines perpendicular to the other two to create the 'Quad'
I knew from past experience that Max decides to allocate random colours when the user is drawing out the 'Splines' so, by clicking on the coloured-square next to the line's text field, there is the option to uncheck 'Use Random Colours' The image above shows the first four squares that made up the lower part of my chin
I will point out that once I had progressed until this stage shown here, I hadn't realized that I needed to enable the little magnet w/3 icon on the menu tab
This meant that I wasn't able to attach them all at the end(as I had previously thought), but I needed to make sure that this icon was triggered before I even began the 'Splines'
I finally reached the stage (after restarting it all over) where I had covered every possible 'Quad' that I had drawn out and I was ready to attach them all together
This was achived by converting one complete 'Splined-Square' into an 'Editable Poly' and then selecting the 'Attach (from List)' button that comes under the 'Edit Geometry' sub-menu on the right-hand side
I made sure to keep my fingers crossed before I selected the 'Attach' button and this was the result of the concentration I applied during the time spent creating the Spline-Modelled head
Of course, the eye socket, lips and nostrils are intended to be left vacant for now until I apply the next step
I have to say your Topology looks absolutely superb!
ReplyDeleteOnly thing to remember is to 'Weld' all the vertices together before you start pulling everything out (Select them all and then hit the small table icon next to 'Weld')
Otherwise, looking forward seeing more developments! :D